(from the maker)
MUGEN MUSOU「INFINITY」-Black Matte-
[The toe tip has undergone a minor change, and the attached spare toe tip has increased by one]
We have overturned common sense with our technology that is always ahead of the curve, and have created history and legends. We have also succeeded in overturning common sense with new technology. We evolve and move forward into the future. This “- INFINITY -” will invite you to new possibilities and individuality. I want you to imagine “Kendama that you can imagine and create”.
Tip: Maple (with 2 replacements Ash & Sakura)
String: Nylon (black)
Ken height: 16.4 cm Ken
Tip length: 4.5 cm
Ball size: 6.1 cm
Platter: 4.8 cm
Small plate: 4.4 cm
Middle plate: 3.9 cm
String slit adopted
Medium countersunk hole type
How to Assemble:
This kendama can be disassembled into 4 parts: Ball, plate body, sword tip, middle grip plate
There are 2 holes in the body and a hole through which the string is passed.
Pass the string from the top of the ball through the half-circle slit and tie the knot.
Pull the string a little and insert the tip of the sword into the plate so that the groove dug in the tip of the sword comes to the string.
A screw is attached to the tip of the sword, so it can be combined with the part of the grip middle plate.
At that time, the screws are tightened by rotating the middle plate of the grip (clockwise).
Rotate it in the opposite direction (counterclockwise) to loosen the screw.
Tighten until the groove dug in the tip of the sword is hidden. Also, there is a logo on the middle plate of the grip, so tighten it until it disappears.
Tighten until both marks are hidden and do not over tighten. Over-tightening may cause damage.
Tips for when the toe tip does not come off:
Place the detached support parts on a flat floor.
Place the upper part on top of it so that the screws are not misaligned.
Put your palms on both sides of the body and apply your weight vertically from directly above to push up the toes.
Pull the toe straight with your finger to remove it.
After replacing the parts you like, insert each part so that the letter part is facing the front, and turn the lower part clockwise to assemble.
How to replace tip. (click here)